dollar80 wrote:like your work so far!
Word of warning regarding your nice clean butterfly discs? I know Nissan GTR butterflies have a special 'paint' around the edges of them to help seal them in the barrel for idle control - its a common problem for keen DIYer's and even workshops thinking they look dirty when building a new motor - clean all that off and once reassembled it results in a really high idle - like 2000+rpm with no way of lowering it externally (not enough adjustment from the factory to allow for that).
Dont know if the same applies to the Toyota parts but worth checking out before you reassemble! Looking at your pics it does seem 'dirtier' around the edges so I suspect it might be so.
You can buy the paint - cant remember what its called now but loctite/threebond make it.
sailaholic wrote:You can get some a decent profile from a regrind cam and I found it to be less than half the cost of a billet set.
Sent from my GT-I9100 using Tapatalk 2
Apu wrote:There's a video on YouTube with Fariqe Hairuman talking about Works Engineering modded car. One of the item he shows is the throttle body which seals enough to be water tight.
Nit sure if that us relevant to your question here?
Users browsing this forum: No registered users and 0 guests